Tamiya F-2001 fit issue
0
26
G'day all
Currently working on Tamiya's F-2001 & am finding an issue as I dry fit the cowling.
With the cockpit half firmly attached to the floor, I place the engine cowling in place & ensure it lines up & beds down correctly over the little rebates on the back of the cockpit tub - thus flush panels. The issue I see is that there is a noticeable gap of approx. 1-2mm at the rear edge of the engine cowling as it meets the floor.
Has anyone else had the same issue?
Can I expect this gap to close once the engine is cemented to the floor?
Currently working on Tamiya's F-2001 & am finding an issue as I dry fit the cowling.
With the cockpit half firmly attached to the floor, I place the engine cowling in place & ensure it lines up & beds down correctly over the little rebates on the back of the cockpit tub - thus flush panels. The issue I see is that there is a noticeable gap of approx. 1-2mm at the rear edge of the engine cowling as it meets the floor.
Has anyone else had the same issue?
Can I expect this gap to close once the engine is cemented to the floor?